© 2012-2021 SOTA Instruments Inc.
Page 6 of 14
|
www.sota.com
The Silver Pulser Model SP6 Manual
HOW TO USE THE MICROPULSING FUNCTION
1. Place the 9-Volt Alkaline battery in the unit.
a. On the back of the unit, slide off the
battery cover.
b. Position the 9-Volt Alkaline battery so
the positive (+) and negative (-) terminals
line up as in image 1.
Note: The smaller circle on the battery
matches the smaller circle in the case
… the larger battery circle matches the
larger circle in the case.
c. Slide the 9-Volt Alkaline battery into the case and push down. Slide the cover back
onto the unit.
2. Attach the Conductive Rubber Probes to the
Micropulsing Cord by gently sliding the Rubber
Probes over the metal pins on the Micropulsing Cord,
as in image 2.
Note: Except to occasionally clean them, the Rubber
Probes can stay on the Micropulsing Cord between
uses.
3. Clean the wrist area
to remove oils from the
skin. This will allow for better conductivity.
4. Insert the Micropulsing Cord into the jack on the unit
as shown in image 3. The USB symbol on the plug
should be facing up. When the plug is positioned
correctly, it will slide in gently. Do not force.
5. Slide the clip on the back of the Silver Pulser into the
holding clip on the Arm Band as in image 4 on page 7.
6. Slide the Arm Band, with the unit and cord, up the arm
to a comfortable position. Tighten the band to secure it
in place as in image 5 on page 7.
1
2
3