Sorensen SFA Series, Operation Manual

Page: 12 / 58

Contents Sorensen SFA Series
3.1.1 Shaft Lock (Option) ..............................................................................3-4
3.2
Local Operation ................................................................................................3-4
3.2.1 Floating and Polarized Output ..............................................................3-5
3.2.2 Initial Setup...........................................................................................3-5
3.2.3 Current Mode Operation.......................................................................3-6
3.2.4 Overcurrent Protection .........................................................................3-6
3.2.5 Analog Control Connector (J1) .............................................................3-7
3.3
Remote Current Programming .......................................................................3-11
3.4
Remote Sensing.............................................................................................3-12
3.5
Remote Output On/Off Control.......................................................................3-14
3.6
Remote Overcurrent Setpoint.........................................................................3-15
3.7
Remote Shutdown (S/D) ................................................................................3-16
3.8
Master/Slave Operation..................................................................................3-16
3.8.1 Parallel Operation...............................................................................3-16
3.8.2 Series Operation ................................................................................3-17
SECTION 4
VERIFICATION AND CALIBRATION ................................. 4-1
4.1
Introduction.......................................................................................................4-1
4.1.1 Verification and Calibration Cycle ........................................................4-1
4.1.2 Preparation ...........................................................................................4-1
4.2
Standard Verification and Calibration Procedure .............................................4-2
4.2.1 Current Mode .......................................................................................4-2
4.2.2 Resistor Programming Current Sources ..............................................4-3
4.3
Isolated Analog (Option) Verification and Calibration Procedure .....................4-3
4.3.1 Current Mode .......................................................................................4-4
SECTION 5
MAINTENANCE................................................................. 5-1
5.1
Introduction.......................................................................................................5-1
5.2
Preventive Maintenance...................................................................................5-1
5.3
Fuses................................................................................................................5-3
M550292-01 Rev C
ii