14
Parametrisation
5
5
The
fi
rst time the controller is turned
on and after the language and time
are set, a query appears as to whether
you want to parametrise the
controller using the commissioning
help or not. The commissioning help
can also be terminated or called up
again at any time in the special
functions menu. The commissioning
help guides you through the neces-
5.1 Commissioning help
Caution
Observe the explanations for the the individual parameters on the
following pages, and check whether further settings are necessary
for your application.
5.2 Free commissioning
If you decide not to use the commissioning help, you should make the
necessary settings in the following sequence:
- Menu 10.
Language (see 15.)
- Menu 3.
Time, date and operating times (see 8.)
- Menu 5
Settings for heat circuit, all settings (see 10.)
- Menü 6.
Protective functions if necessary (see 11.)
- Menü 7.
Special functionsif necessary (see 13.)
Finally, menu 4.2 under operating mode „Manual“ should be used to test
the switch outputs with the consumers connected, and to check the sensor
values for plausibility. Then switch on automatic mode.
sary basic settings in the correct order, and provides brief descriptions of
each parameter in the display.Pressing the „esc“ key takes you back to the
previous value so you can look at the selected setting again or adjust it if
desired. Pressing the „esc“ more than once takes you back step by step to
the selection mode, thus cancelling the commissioning help. Finally, menu 4.3
under operating mode „Manual“ should be used to test the switch outputs with
the consumers connected, and to check the sensor values for plausibility. Then
switch on automatic mode.
Caution
Observe the explanations for the the individual parameters on the
following pages, and check whether further settings are necessary
for your application.