12
LUBRICANTS
Treadmills are oiled when they are shipped, but the lubricity of the treadmills is often checked to help keep the
treadmills at peak use. The treadmill must be lubricated after one year of use or 100 hours of operation.
After 30 hours or 30 days of use, in the treadmill stationary state, pull the starting belt from the side to reach as far as
possible to touch the table surface, if you feel touch the lubricant, do not need to add lubricant;(Use non-petroleum
lubricants).
How to add lubricant.
Please adhere to the following instructions carefully.
Open the side bar on the front left of the refuelling decorative cover. Insert the bottle into the
opening to measure the size, use a pair of scissors or art knife to cut off tip of the bottle to
size. Place the bottle into the hole and squeeze the bottle (as illustrated to refuel). Please
ensure the oil bottle tip of the thin rod is inserted correctly and securely into the fuel pipe on
the platform and then pour oil into it.
13
ERRORS AND TROUBLE SHOOTING
13.1
The electronic table displays the error message codes:
Fault code
Description of the fault
Fault handling
E1
Communication anomalies: power-on control
and electronic table communication
abnormal
Possible causes: electronic control and electronic table communication is
blocked, check the electronic table to the next section of the control
communication line of the connection, to ensure that each core is fully
inserted. Check if the electronic table is connected to the controller break,
replace the cable.
E2
High voltage fault
Check the motor line for damage, odour, replace the motor.
E3
motor detected
Check that the motor line is connected and reconnect the motor line.
Check the motor line for damage, odor, replace the motor.
E5
Over current protection: In the operational
state, the control continuously detects
that the DC motor current is greater than
the amount of fixed current, up to 3
seconds
Possible reasons: more than the rated load caused by excessive current,
system self-preservation, or a part of the treadmill is stuck dead, resulting
in the motor cannot turn, the load is too heavy, the current is too large, the
system self-insurance; There is also checking the motor for over current or
burning odor, replacing the motor, checking the controller for burning air,
replacing the controller, or checking that the supply voltage specifications
are not high or low, retest using the correct voltage specifications.
E6
Explosion protection: abnormal supply
voltage or motor anomalies, etc. lead to
drive motor circuitry damage.
Possible cause: Check if the supply voltage is below normal. 50%, retest
with the correct voltage specifications, check the controller for odour,
replace the controller, check that the motor line is connected, and
reconnect the motor line.
E07
Safety switch not on inserted
Put the security lock in place.
11
Summary of Contents for A90-249V80
Page 16: ......
