21
Troubleshooting guide
The following checklist will help you remedy the problems you may encounter with your unit.
Before going through the checklist below, check the connections and operating procedures.
General
Problem
No sound.
The contents of the memory
have been erased.
Indications do not appear
in the display.
Cause/Solution
•Cancel the ATT function.
•Set the fader control to the center position for two-speaker
systems.
•Rotate the dial clockwise to adjust the volume.
• The power cord or battery has been disconnected.
• The reset button was pressed.
t
Store again into the memory.
Remove the front panel and clean the connectors. See
“Cleaning the connectors” (page 19) for details.
Tape playback
Problem
The sound is distorted.
The AMS does not operate
correctly.
Cause/Solution
The tape head is contaminated.
t
Clean the head with a commercially available dry-type
cleaning cassette.
•
There is noise in the space between tracks.
•
A blank space is too short (less than four seconds).
•
A long pause, or a passage of low frequencies or very low
sound level is treated as a blank space.
Cause/Solution
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
•The broadcast signal is too weak.
t
Use manual tuning.
•The local seek mode is set to ON.
t
Set the local seek mode to OFF (page 12).
Connect a power antenna control lead (blue) or accessory
power supply lead (red) to the power supply lead of a car’s
antenna booster. (When your car has built-in FM/MW/SW
antenna in the rear/side glass only.)
•Tune in the frequency accurately.
•The broadcast signal is too weak.
t
Set to the MONO mode (page 12).
Radio reception
Problem
Preset tuning is not possible.
Automatic tuning is not
possible.
The stations cannot be
received.
The sound is hampered by
noises.
The “ST” indication flashes.
Interference occurs during FM
reception.
The WIDE mode is selected.
t
Set the IF mode to IF AUTO (page 12).
continue to next page
t
Summary of Contents for XR-C5500
Page 23: ...23 ...
