Sony WRT-860A, Operating Instructions Manual

Page: 11 / 36

11
Power Supply
The transmitter can operate on two LR6 (size AA) alkaline
batteries continuously for about 6 hours at 25
°
C (77
°
F).
Inserting the batteries
Battery indication
When you turn the power on, the battery status appears in
the BATT indication on the liquid-crystal display.
Promptly replace both batteries after reaching stage 3
shown in the table.
The indication may be incorrect if the batteries are not new
when inserted. If you plan to use the transmitter for a long
period, it is best to replace the batteries with new ones.
Notes on batteries
•
The BATT indication on the WRR-850A starts flashing
earlier than that on this transmitter.
•
Use new alkaline batteries of the same type, and check the
recommended “useby” date on the bottom of the batteries.
•
Be careful to insert the batteries with the correct polarity.
•
When not using the transmitter for a long period, remove
the batteries to avoid leakage. If a battery does leak, clean
all leakage from the unit and insert new batteries. Leakage
left in the unit may cause poor battery contact. If there
seems to be poor battery contact, consult your Sony dealer.
UHF SYNTHESIZED TRANSMITTER WRT-860
1 2
1
Remove the battery case.
2
Match the polarities and insert the batteries.
You can quickly replace the batteries in the future by
inserting the same type of batteries in an extra battery
case.
3
Reinsert the battery case into the transmitter and press it
to securely lock it into place.
Lights Lights Flashes Goes off
4 3 2 1
BATT
indication
Battery
condition
Less than
half-charge
Almost
exhausted
Completely
exhausted
Good