Sony Walkman MZ-NF810CK, Operating Instructions Manual

Page: 82 / 128

82
While using group function
While using the radio
Track marks
cannot be erased. • This is due to the MiniDisc system limitations. When the data of a
track is fragmented, the track mark of a fragment under 12 seconds
long (recorded in SP stereo), 24 seconds long (recorded in LP2
stereo mode or monaural mode), or 48 seconds long (recorded in
LP4 stereo mode) cannot be erased. You cannot combine tracks
recorded in different recording modes, e.g., a track recorded in
stereo and a track recorded in monaural; nor can you combine a
track recorded with digital connection and a track recorded with
analog connection.
The disc cannot
edit on other
component. • The component does not support LP2 stereo or LP4 stereo.
,
Edit on other component that support LP2 stereo or LP4 stereo.
“TR FULL”
appears even
before the disc has
reached the
maximum track
number or
recording time. • This is due to the MiniDisc system limitation.Repeated recording
and erasing may cause fragmentation and scattering of data.
Although those scattered data can be read, each fragment is
counted as a track. In this case, the number of tracks may reach 254
and further recording is not possible. To continue recording, erase
unnecessary tracks.
Symptom Cause/Remedy
The group
function does not
operate. • While using a disc with no group setting, an attempt was made to
select some group-related menu.
,
Use a disc with group setting.
A track cannot be
recorded to a new
group. A new
group cannot be
created. • This is due to the MiniDisc system limitations. Group information
has been written to the area where the disc name is stored. The disc
name and track names are recorded in the same area, which can
store a maximum of approximately 1,700 characters. If the total
number exceeds this amount, a new group cannot be created even
though group mode is on. It is also impossible to make group
settings at this time.
Symptom Cause/Remedy
The radio does not
operate. • The supplied remote control is connected to other unit than this
recorder. The supplied remote control should be used with this
recorder only.
• After confirming that “NO DISC” has disappeared from the
display on the remote control, press RADIO ON/OFF again on the
remote control.
Symptom Cause/Remedy