12
MZ-N910
Operation in Setting the Test Mode
• When the test mode becomes active, first the display check mode
is selected.
• Other mode can be selected from the display check mode.
• When the test mode is set, the LCD repeats the following dis-
play.
Remote commander LCD display
Set LCD display
•
When the
X
key on the set or the
key on the remote
commander is pressed and hold down, the display at that time is
held so that display can be checked.
Releasing the Test Mode
For test mode set with the method
1
:
Turn off the power and open the solder bridge on SL803 (TEST)
on the MAIN board.
Note:
Remove the solders completely. Remaining could be shorted with
the chassis, etc.
For test mode set with the method
2
or
3
:
Turn off the power.
2
In case of setting the test mode only by keys on the set:
In the normal mode, turn on the
[HOLD]
switch. While press-
ing the
[GROUP]
key press the following order:
>
t
>
t
.
t
.
t
>
t
.
t
>
t
.
t
X
t
X
3
In case of setting the test mode by keys on the set and
remote commander:
In the normal mode, turn on the
[HOLD]
switch on the set.
While pressing the
x
key on the set, press the keys on the
remote commander with the following order:
>
t
>
t
.
t
.
t
>
t
.
t
>
t
.
t
t
Note:
If electrical adjustment (CD and MO overall adjustment) has not
been finished completely, “ERROR” is displayed on LCDs of the
set and the remote commander.
SECTION 4
TEST MODE
Outline
• This set provides the Overall adjustment mode that allows CD
and MO discs to be automatically adjusted when in the test mode.
In this overall adjustment mode, the disc is discriminate between
CD and MO, and each adjustment is automatically executed in
order. If a fault is found, the system displays its location. Also,
the manual mode allows each individual adjustment to be auto-
matically adjusted.
• Operation in the test mode is performed with the set. A key
having no particular description in the text, indicates a set key.
• For the LCD display, the LCD on the remote commander is
shown, but the contents of LCD display on the set are same.
(Both displays may be displayed.)
Setting Method of Test Mode
There are three different methods to set the test mode:
1
Short SL803 (TEST) on the MAIN board with a solder bridge
(connect pin
<zx.
of IC801 to the ground) and turn on the power.
– MAIN Board (Side A) –
SL803 (TEST)
V1.400
Microcomputer
version
display
All off
All lit
003
Ver 1.400
003
Microcomputer
version
display
All off
All lit
