34
3D video images
Others
Symptom
Cause and Remedy
The video image does not seem like
3D video images.
Check if the 3D glasses are turned on. (page 13)
Make sure that the battery in the 3D glasses is sufficiently charged.
Set “2D-3D Display Sel.” to “Auto” or “3D.” (page 24)
Check if the input signals are compatible 3D signals. (page 40)
The 3D signals may not be input depending on the specifications of the connected AV selector/AV
amplifier/external equipment. If the 3D signal is not input, confirm the specifications and/or settings
of the AV selector/AV amplifier/external equipment.
When the viewing position is too far from the unit, the 3D glasses may not be able to display the
images properly. (page 13)
The projection image size is not appropriate. Set the zooming magnification to low or watch the
image from farther away from the projection surface. (page 44)
For details, see “Precautions for use” of “Using the 3D Glasses.” (page 13)
Symptom
Cause and Remedy
The fan is noisy.
Check the setting of “High Altitude Mode” on the Setup
menu. (page 23)
Make sure that the room temperature is not too high.
Check to see if the air filter is not clogged. (page 35)
Check the installation requirements of the unit.
Fan speed increases to maintain the product reliability of the projector’s components in a room
where the temperature is higher than normal. The fan noise becomes slightly louder in these rooms.
The approximate normal temperature for the unit is 25°C (77°F).
The lens shift cannot be adjusted.
The lens shift cannot be adjusted over the range of movement. Adjust the lens shift within the range
of movement. (page 8, 44)
Summary of Contents for VPL-VZ1000ES
Page 47: ...Sony Corporation ...
