19
Adjusting the input level of the audio signal
from equipment connected to EXT IN-1/2
connectors
1
• To adjust the output of the conference
microphone, set the MIC/LINE switch of the
EXT IN connector, to which the conference
microphone to be adjusted is connected, to MIC.
• To adjust the output of external equipment, set
the MIC/LINE switch of the EXT IN connector,
to which the external equipment to be adjusted
is connected, to LINE.
2
Adjust either MIC/LINE 1 or MIC/LINE 2,
corresponding to the equipment to be adjusted, so
that the level meter pointer indicates about 0 VU.
Note
In this case, do not rotate the D/C UNIT SP
control and D/C UNIT MIC control because they
have already been adjusted as described in
“Adjusting the output level of the audio signal to
the chairman’s unit/delegate’s unit” (previous
page).
To select the microphone mode of the chairman’s
unit/delegate’s units
Select the microphone mode (whether the number of
speakers is limited) according to the conference type.
To limit the number of speakers to five: Press the
MIC LIMIT ON/OFF button such that the button
indicator lights.
Rear of the control unit
Front of the control unit
1
2
Note
When the power of the control unit is turned off, the
MIC LIMIT ON/OFF button is automatically reset to
OFF even if it has been set to ON.
To set the mode to limit the number of speakers to
five after the power of the control unit is turned on
again, press the MIC LIMIT ON/OFF button such
that the button indicator lights.
To allow all speakers to participate freely: Press
the MIC LIMIT ON/OFF button such that the button
indicator goes out.
Level meter
Summary of Contents for SX-C700A
Page 4: ...4 ...
