STR-DN1080/ZA810ES
17
2-7. MB-1613 BOARD BLOCK-1
• Continued on 2-8 (page 18).
1
FFC 27P (CN3004)
(See Fig. C)
2
FFC 22P (CN8002)
(See Fig. C)
3
FFC 22P (CN8001)
(See Fig. B)
4
COAX board cable
connector
(CN8006)
qa
FRONTJACK board cable
connector
(CN501)
qs
DCDC board cable
connector
(CN301)
7
MAIN board cable
connector
(CN8000)
8
MAIN board cable
connector
(CN8004)
6
MAIN board cable
connector
(CN8003)
terminal side
CN3004
CN8002
MAIN board
MB-1613 board
FFC 22P
MB-1613 board
FFC 27P
5
Cut the cable tie.
0
Cut the cable tie.
0
Cut the cable tie.
rear side
cable tie
CN8004
CN8003
D
D
9
Remove the cable
from the lead pin.
:LUHVHWWLQJ
:LUHVHWWLQJ
))&3RU))&3VHWWLQJ
CN8001
terminal side
FFC 22P
))&3VHWWLQJ
:LUHVHWWLQJ
cable tie
cable tie
lead pin
power transformer
Note 1:
The cables must not touch the heat sink.
Note 2:
Make sure that the sleeve ferrite clamp does not
protrude toward the rear side past the guide line.
Note 3:
Arrange the cables so that they are parallel with
the heat sink, and fasten them in place using
cable
ties.
MB-1613 board
guide line
rear side
rear side
rear side
DCDC board
MB-1613 board
)LJ&!
)LJ%!
terminal side
rear side
right side
sleeve ferrite
clamp
heat sink
DCDC board
–
6LGHYLHZ
–
–
7RSYLHZ
–
Note 4:
During reassembly, use new cable ties
to fasten the wires back in place as
they were before disassembly.
heat sink
SYS SET
2020/11/17 21:24:35 (GMT+09:00)
