2-36 (E)
SRX-T615
3. Click “On” of the radio button in [Test Pattern].
The following image is displayed on the screen.
4. Move the cursor to the center of the image by clicking the
[&]
/
[(]
/
[*]
/
[)]
buttons.
5. Adjust R (Red) and B (Blue) images so that they are overlaid with G (Green) image using the
[_]
/
[+]
buttons while viewing the images.
n
When you click the
[_]
/
[+]
buttons, the image moves in the direction based on the IMAGE FLIP Off
setting. Therefore, if the image is displayed in the state of IMAGE FLIP On, the image moves in the
opposite direction. (Even if the IMAGE FLIP is On, the cursor moves in the same direction as in the
state of IMAGE FLIP Off.)
t
The correction moving amount of the center in the horizontal direction is smaller than that of other
adjustment portions in the horizontal direction. This is not due to the abnormal state but because of
the specification.
Note on using the 3D lens
When adjusting the 3D image, hide one lens at a time. At that time, not only the image but also the
cursor moves reversely in both horizontal and vertical directions.
6. Move the cursor to the portion other than the center of the image by clicking the
[&]
/
[(]
/
[*]
/
[)]
buttons.
7. Adjust the image using the
[_]
/
[+]
buttons in the same way as step 5.
8. Repeat steps 6 and 7 to adjust all portions.
9. When the adjustments of all portions are completed, click “Off” of the radio button in [Test Pattern].
10. Click “Off” of the radio button in [Zone Adjust].
n
If [Zone Adjust] was set to “Off”, the image for fine adjustment does not disappear from the screen. To
disappear the image, first set [Test Pattern] to “Off”, then set [Zone Adjust] to “Off”.
2-6. Color Space Conversion (CSC Adjustment)
The color space of this unit can be corrected for each color reproduction range.
n
.
The CSC adjustment cannot be properly performed when gamma is misaligned.
It is recommended to perform gamma and uniformity adjustments in advance.
Perform the gamma adjustment of this unit using a gamma adjustment tool (PCAB-G).
.
Perform gamma and uniformity adjustments before CSC adjustment when changing the number of lamps.
The color may subtly vary depending on the number of lamps.
Cursor
Center of image
