Sony PWS-4500, Operation Manual

Page: 12 / 63

12
Setting the System and Boards
Chapt
er
3
Set
u
p
Setting the System and
Boards
You set the system frequency and board settings for the
unit using the web menu. The settings are specified using
a setup wizard.
1
Display the [System] screen of the web menu, and
click the [Board] tab.
2
Click the [Setting] button.
The [Step 1] screen appears.
3
Select the system frequency, input/output mode, and
the number of input/output boards installed, then click
the [Next] button.
System frequency
• 23.98 Hz
• 24 Hz
• 25 Hz
• 29.97 Hz
Input/output mode
• SDI Mode
• NMI Mode
Number of input/output boards
• 2 Boards
• 4 Boards
• The input/output mode sets whether the NMI or SDI
signal input/output is used as a reference for the
whole unit. The input/output mode cannot be set
independently for each port.
• When the input/output mode is set to “SDI,” signals
output from NMI lag by one frame. When the input/
output mode is set to “NMI,” signals output from
SDI lead by one frame. In either case, the phase of
the audio signal and TC signal are offset.
• Input signals can use either SDI or NMI only.
• When the input/output mode is set to “NMI” and the
video signal format is QFHD (3840:2160), 1× or 2×
speed recording can be selected. When the video
signal format is HD (1920:1080), only 1× speed
recording can be selected. HD (1280:720) video
signal format cannot be selected.
Click the [Next] button to display the [Step 2] screen.
4
Select the input/output type of each port, and click the
[Next] button.
• Input (single-system input)
• HD Multi-Input (dual-system input)
• Input with 2 Boards (using two boards)
• Output (single-system output)
• HD Multi-Output (dual-system output)
• HD Cut Out (for 4K/QFHD video HD cutout)
For high frame rate recording (HD 300i/359i/400i/
479i/300p/359p/400p/479p, 4K 100p/119p), two
boards are used.
No audio signal is recorded if high frame rate
recording is selected.
Click the [Next] button to display the [Step 3] screen.
5
Select the video codec of each port, and click the
[Next] button.
The [Step 4] screen appears.
6
Select the video signal format of each port, and click
the [Next] button.
For each port, select the video signal format group
from the matrix.
The [Step 5] screen appears.
7
Select the port grouping to operate in sync, and click
the [Next] button.
The [Step 6] screen appears, displaying the selections
made on the [Step 1] to [Step 5] screens.
8
Check the selected items, and click the [Submit]
button. A confirmation message appears. Click [OK].
The unit restarts automatically and the settings are
enabled.
To set each port individually, see “Port Screen” (page 29)
of the web menu.
Changing the system frequency or other board settings will
disable the loop recording area settings. Reconfigure the
settings on the [Loop] tab on the [Storage] screen of the
web menu, as required.
Notes
Note