PFV-L10
1-6 (E)
1-6. Rack Mounting
1-6. Rack Mounting
PFV-L10 can be mounted on a 19-inch standard rack for use.
Mount PFV-L10 on the rack properly in the procedure below using a specified rack mounting kit.
Specified rack mounting kit: RMM-10
n
PFV-L10 may not be able to be mounted on a 19-inch standard rack using a rack mounting kit other than
the specified one.
Components of RMM-10
.
Rack brackets ................................................................. 2 pieces
.
Rack mounting adaptor (right) ....................................... 1 piece
[Including two screws (B 4
x
6: 7-682-560-09)]
.
Rack mounting adaptor (left) ......................................... 1 piece
[Including two screws (B 4
x
6: 7-682-560-09)]
.
Rack bracket fixing screws (B 4
x
6: 7-682-560-09) ...... 6 pieces
.
Adaptor fixing screws (B 4
x
10: 7-682-560-10) ............ 6 pieces
Required other parts
To mount the unit on the rack, the following parts are required.
.
Screws (RK 5
x
16: 7-682-378-04) ................................. 4 pieces
.
Ornamental washers (2-297-913-01) ............................. 4 pieces
1-6-1. Notes on Rack Mounting
w
.
Fix the rack on the horizontal and firm floor with bolts to prevent it from turning over or moving.
If the rack overturn due to the weight of the unit, this may cause a death or serious injury.
.
Use the specified rack mounting kit.
If not, the unit may fall because of insufficient strength. This causes an in jury.
.
After rack mounting, be sure to tighten the screws of the rack angle and fix this unit to the rack.
If not, this unit may slide and fall from the rack. This causes an injury.
c
Attention when this unit is installed in the rack:
.
Mount the unit with two or more persons.
.
Be careful not to put your hand or finger in the rack mount rail.
.
Install in a stable posture.
n
Install a ventiloting fan in the rack to prevent the increase in the temperature inside a rack when multiple
units are put in one rack.
