Sony NSA-PE1, Operating Instructions Manual

Page: 17 / 20

NSA-PF1(US/FR) 3-877-457- 71 (1)
17
- If battery leakage occurs, avoid touching the liquid. Wipe the
liquid thoroughly before inserting new batteries.
 Do not expose the remote sensor to direct sunlight or lighting
apparatus. Remote control operation may be affected.
Troubleshooting
If you experience any of the following difficulties while using the
system, use this troubleshooting guide to help remedy the
problem before requesting repairs. Should any problem persist,
consult your nearest Sony dealer.
No sound is output from the system.
The power of the system is off.
 Check the power of the system.
Playback component is not connected correctly.

Check that the component is connected correctly.
Volume of the system is low.

Check the volume of the system.
Input source of the system is not selected.

Select the input of the system correctly.
The settings on a digitally-connected component is not set to
Linear PCM.
 Check that a digitally-connected component is set to Linear
PCM.
There is hum or noise.
Playback component is not connected correctly.

Check that the component is connected correctly.
Audio components are placed near other components that are
causing noise (TV set, etc.).
 Place the audio components farther away from the TV set, etc.
Color irregularity occurs on TV monitor.
 Place the system farther away from the TV set.
Three INPUT SELECT indicators flash at the same time.
 Turn off the system, unplug the AC power cord (mains lead), and
then consult your nearest Sony dealer.
Specifications
Amplifier section
POWER OUTPUT AND TOTAL HARMONIC DISTORTION (FTC
Output Power):
37 Watts × 4, 8 ohm (Tweeter) + 37 Watts, 8 ohm (Mid Range) + 65
Watts, 4 ohm (Woofer) at 50 Hz - 20 kHz, 1% THD Total harmonic
distortion from 250 milli watts to rated output.
Speaker system 3 way active speaker
Speaker unit Woofer: 13 cm cone type, Mid range: 7 cm cone
type, Tweeter: organic glass type
Enclosure system Bass reflex
Frequency range 50 Hz - 20 kHz
Inputs
Analog
Line (pin jack L/R)
Digital COAXIAL (pin jack), OPTICAL (TOS),
Linear PCM 2 ch (32, 44.1, 48, 96 kHz/16 bit,
24 bit)
General
Power requirements 120 V AC, 60 Hz
Power consumption 85 W
0.3 W (standby mode)
Dimensions (approx.) 325 mm × 1,845 mm × 325 mm (w/h/d)
Mass (approx.)
12.5 kg
Supplied accessories AC power cord (mains lead) (1)
Cleaning cloth (1)
Remote control (1)
R03 (size AAA) batteries (2)
Operating Instructions
Design and specifications are subject to change without notice.