26
MZ-B10
Power Supply Adjustment Auto Item Feed
Note:
This mode is available to perform the temperature correction and
power supply adjustment without entering the manual mode.
• Setting method of power supply adjustment auto item feed mode.
1. Set the test mode (see page 16)
2. Press the
.
key or press the
[VOL --]
key on the remote
commander to activate the overall adjustment mode.
3. Press the
[SPEED CONTROL --]
key or the
[P MODE]
key on
the remote commander to set the temperature correction mode.
4. To change the initial value adjust with the
[SPEED CONTROL
+]
or
[SPEED CONTROL --]
key.
Press the
X
key to write the adjusted value, and the item num-
ber increases automatically.
When not writing the adjusted value, press the
>
key to move
to the next item.
5. Connect a digital voltmeter to the measuring points on the
MAIN board, and adjust the voltage with the
[SPEED CON-
TROL +]
or
[SPEED CONTROL --]
key. (see page 21 to 24)
Press the
X
key to write the adjusted value, and the item num-
ber increases automatically.
6. When not writing the adjusted value, press the
>
key to move
to the next item. The
.
key is available to back to the last
item.
7. The following message is displayed after all power supply
adjustments finish.
8. Press the
x
key to return the test mode (display check mode).
• Configuration of power supply adjustment auto item feed
Assy**
000
Set LCD display
SetTmp **
015
Set LCD display
**
: Adjusted value
VC1 L **
741
Set LCD display
**
: Adjusted value
ADJ OK
000
Set LCD display
.
key
>
key
.
key
>
key
.
key
>
key
SPEED CONTROL –
key or
P MODE
key on the remote
commander
000Assy
**
015 SetTmp 19
741 VC1 L
**
742 VC1 H
**
743 VC2 Lo
**
.
key
>
key
>
key
>
key
>
key
.
key
>
key
.
key
>
key
749 REG3 H
**
751 VREC L
**
752 VREC M
**
753 VREC H
**
>
key
000 ADJ OK
.
key
.
key
>
key
744 VC2 Hi
**
745 REG1
**
.
key
747 REG3L1
**
748 REG3L2
**
.
key
.
key
>
key
Summary of Contents for MZ-B10 - Minidisc Voice Recorder
Page 63: ...MZ B10 63 MEMO ...