Sony Multiscan CPD-M151, Operating Instructions Manual

Page: 6 / 104

6
Getting Started
Setup
Before using this monitor, check that the following items are
included in your carton:
• LCD monitor (1)
• Rear cover (1)
• Power cord (1)
• AC adapter (1)
• HD15 video signal cable (1)
• Macintosh adapter (1)
• Rubber pads (2)
• Windows
Monitor Information Disk/Utility Disk (1)
• Macintosh Utility Disk (1)
• Warranty card (1)
• These operating instructions (1)
Set up
You can set up the monitor on its stand or use it without the
stand. The procedure of connecting cables and attaching the
rear cover differs depending on how you set up the
monitor. In either case, read:
Step 1: Connect the monitor to the computer
Step 2: Connect the power cord
to connect the monitor to the computer and power source.
The connection is explained using the stand-type set up for
the illustration; however, the connector to be connected and
adapter required are the same even when the stand is not
used.
Stand set up
Connect the video signal cable and power cord, then attach
the rear cover.
To adjust the angle
The tilt feature allows the
monitor to be adjusted
within 65
°
upward. To
adjust the angle, hold at the
bottom with both hands as
illustrated.
65
°
Set up without the stand
First detach the stand, and then connect the video signal
cable and power cord. Attach the rear cover. The rear cover
becomes the stand. See “Using the monitor without the
stand” on page 8.
To adjust the angle
The tilt feature allows the
monitorto be adjusted within
25
°
upward. To adjust the
angle, hold at the bottom
and open the stand as
illustrated.
25
°