Sony MDX-C8900R, Service Manual

Page: 25 / 88

– 25 –
3. Adjust the volume RV2 on TU1 by turning clockwise untill
“0” is shown next to “FM” on the display window, If “0” is
already shown or the volume RV2 has been turned too far,
turn it back counterclockwise untill “0” is disappeared once,
then try this adjustment.
Display
Adjustment Location: See page 28.
SECTION 3
ELECTRICAL ADJUSTMENTS
TEST MODE
This set have the test mode function. In the test mode, FM Auto
Scan/Stop Level and MW Auto Scan/Stop Level adjustments can
be performed easier than it in ordinary procedure.
<Set the Test Mode>
1. Set the “power select” switch (SW500) is “A (ON)” position.
2. Turn ON the regulated power supply. (All LEDs on the set
lights up, and the clock is displayed.)
Note:
Press the
[OFF]
button, if the clock is not displayed.
3. Push the preset
[4]
button.
4. Push the preset
[5]
button.
5. Press the preset
[1]
button for more than two seconds.
6. Then the display indicates all lights, the test mode is set.
<Release the Test mode>
1. Push the
[OFF]
button.
2. Return the “power select” switch (SW500) to initially set po-
sition.
MD SECTION
MD section adjustments are done automatically in this set.
See the adjustment location from on page 28 for the ad-
justment.
TUNER SECTION
0 dB=1µV
Cautions during repair
When the tuner unit is defective, replace it by a new one be-
cause its internal block is difficult to repair.
Note: Adjust the tuner section in the sequence shown below.
1. FM Auto Scan/Stop Level Adjustment
2. FM Stereo Separation Adjustment (Wide)
3. FM Stereo Separation Adjustment (Narrow)
4. FM RDS S-Meter Adjustment
5. MW Auto Scan/Stop Level Adjustment
FM Auto Scan/Stop Level Adjustment
Setting:
[SOURCE]
button : FM
Procedure:
1. Set to the test mode.
2. Push the
[SOURCE]
button and set to FM.
Display
set
antenna jack (CN1)
FM RF signal
generator
Carrier frequency : 98.00 MHz
Output level : 22 dB (12.6
µ
V)
Mode : mono
Modulation : 1 kHz, 22.5 kHz deviation (30%)
0.01
µ
F
SHUF
REG
SHUF
REG