Sony LMD-940W, Operating Instructions Manual

Page: 26 / 31

Adjustment Using the Menus
26
Submenu Setting
PARALLEL REMOTE Selects the PARALLEL REMOTE
connector pins for which you want
to change the function.
You can assign various functions to
1 to 4 pins and 6 to 8 pins. The
following lists the functions you
can assign to the pins.
• – – – (“– – –”: No function is
assigned.)
• COMPOSITE
• SDI
• HDMI
• OVERSCAN
• FULL
• NORMAL
• NATIVE
• 4:3
• 16:9
• TALLY R
• TALLY G
• BLUE ONLY
• MONO
• H/V DELAY
• 16:9 MARKER
• 15:9 MARKER
• 14:9 MARKER
• 13:9 MARKER
• 1.85:1 MARKER
• 2.35:1 MARKER
• 1.85:1 & 4:3 MARKER
• 4:3 MARKER
• CENTER MARKER
• MARKER MAT HALF
• MARKER MAT BLACK
• WFM/ALM
Notes
• If you use the PARALLEL
REMOTE function, you need to
connect cables. For more details,
see page 29.
• Set MARKER ENABLE
(page 22) to ON to control the
aspect marker and center
marker.
SERIAL REMOTE
MONITOR
CONTROLLER
CONNECTION
Selects the mode to be used.
•
OFF : SERIAL REMOTE does
not function.
• ETHERNET : The monitor is
controlled by the command
of Ethernet.
• BKM-15R : Sets BKM-15R.
Sets the monitor setting.
MONITOR ID : Sets the ID
of the monitor.
GROUP ID : Sets the group
ID of the monitor.
IP ADDRESS : Sets the IP
address.
SUBNET MASK : Sets the
subnet mask.
(255.255.255.000)
DEFAULT GATEWAY :
Sets the default gateway on
or off.
ADDRESS : Sets the default
gateway.
CANCEL : Selects to cancel
the setting.
CONFIRM : Selects to save
the setting.
Sets the address of the remote
controller.
IP ADDRESS : Sets the IP
address.
SUBNET MASK : Sets the
subnet mask.
(255.255.255.000)
DEFAULT GATEWAY :
Sets the default gateway on
or off.
ADDRESS : Sets the default
gateway.
CANCEL : Selects to cancel
the setting.
CONFIRM : Selects to save
the setting.
Sets the connection of the monitor
and the controller.
PEER TO PEER : for one
to one connection
LAN : for connection via a
network
Submenu Setting