5-49 (E)
Digital Cinema Dual System
3. Tap
[New]
in the Profile pane.
The New GPIO Profile Setting screen is displayed.
4. Enter data in Profile Name and set the items below.
.
Device:
Select whether to use a GPIO pin or eCNA.
t
The IP address of eCNA equipment must be registered when using eCNA. (Refer to Section 5-11.)
.
I/O:
Set an output pin or input pin.
For an input pin, also set the delay time (500 to 2000 ms) from an input signal.
.
Trigger:
Set the type of a trigger. (Pulse/Level)
Also set the pulse width (Output: 100 to 2000 ms, Input: 450 to 2000 ms) when a
pulse is selected.
.
Active State: For an input pin, set the active state of an input signal.
(High: Active when a signal is high, Low: Active when a signal is low.)
5. Tap
[Apply]
.
A profile is set.
t
To change the registered profile, refer to “Change in profile”. To delete the registered profile, refer to
“Deletion of profile”.
Change in profile
1. Place a mark in the check box for the profile, to be changed, in the Profile pane and tap
[Edit]
.
n
Initialization items (DEFAULT_INPUT_PULSE, DEFAULT_OUTPUT_PULSE, and
DEFAULT_OUTPUT_LEVEL) cannot be changed or deleted. When you change the Trigger setting,
delete the applicable Profile once, and then register it as a new registration.
Profile name
Profile value
DEFAULT_INPUT_PULSE
GPIO pin, input, pulse, active high, pulse width 450 ms, and delay time 500
ms
DEFAULT_OUTPUT_PULSE
GPIO pin, output, pulse, active high, and pulse width 100 ms
DEFAULT_OUTPUT_LEVEL
GPIO pin, output, level, and active high
2. Change the profile.
Screen example