T
roub
lesh
ootin
g
27
GB
The color irregularity on a TV screen persists.
• Turn off the TV set once, then turn it on after 15
to 30 minutes. If the color irregularity still
persists, place the speakers farther away from the
TV set.
CD
The disc tray does not close.
• Place the disc correctly.
Play does not start.
• Open the disc tray and check whether a disc is
loaded.
• Wipe the disc clean (page 29).
• Replace the disc.
• Place the disc that this system can play.
• Place the disc correctly.
• Place the disc in the tray with the label side up.
• Remove the disc and wipe away the moisture on
the disc, then leave the system turned on for a few
hours until the moisture evaporates.
• Press
NX
(or CD
N
on the remote) to start
play.
Disc access takes a long time.
• Set “CD POWER ON” by CD power manage
function (page 12).
The sound skips.
• Wipe the disc clean (page 29).
• Replace the disc.
• Try moving the system to a place without
vibration (e.g., on top of a stable stand).
• Try moving the speakers away from the system, or
placing them on separate stands. When you listen
to a track with bass sounds at high volume, the
speaker vibration may cause the sound to skip.
Play does not start from the first track.
• Press PLAY MODE repeatedly until both
“PROGRAM” and “SHUFFLE” disappear to
return to Normal Play.
Tuner
Severe hum or noise/stations cannot be
received.
• Set the proper band and frequency (page 11).
• Connect the antenna properly (page 6).
• Find a place and an orientation that provide good
reception, then set up the antenna again. If you
cannot obtain good reception, we recommend you
connect a commercially available external
antenna.
• The supplied FM lead antenna receives signals
along its entire length, so make sure you extend it
fully.
• Locate the antennas as far away from the speaker
cords as possible.
• Try turning off surrounding electrical equipment.
• Set “CD POWER OFF” by CD power manage
function (page 12).
A stereo FM program cannot be received in
stereo.
• Press FM MODE until “MONO” disappears.
Tape deck
The tape does not record or play, or there is a
decrease in sound level.
• The heads are dirty. Clean them (page 30).
• The record/playback heads are magnetised.
Demagnetise them (page 30).
The tape does not erase completely.
• The record/playback heads are magnetised.
Demagnetise them (page 30).
There is excessive wow or flutter, or the sound
drops out.
• The capstans or pinch rollers are dirty. Clean them
Noise increases or the high frequencies are
erased.
• The record/playback heads are magnetised.
Demagnetise them (page 30).
The tape does not record.
• No cassette is loaded. Load a cassette.
• The tab has been removed from the cassette.
Cover the broken tab with adhesive tape
(page 30).
• The tape has wound to the end.
continued
