- 7 -
SE2AG SELF DIAGNOSTIC SOFTWARE
The identification of errors within the SE2AG chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In the
event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous
flashing LED) and then communicate with each device in turn to establish if a device is faulty. If a device is found to be faulty the relevant
device number will be displayed through the LED (Series of flashes which must be counted).
LED Error Codes
Number of LED
Flashes
Error Description
Checked
Action
02
Balancer error.
In normal mode.
Goes into standby.
03
DC error.
In normal mode.
Goes into standby.
04
Inverter error.
In normal mode.
Goes into standby.
05
NVM error.
In initialisation state.
Goes into standby.
06
IIC error.
In normal mode.
Goes into standby.
07
HDMI error.
In normal mode.
Adds error to error menu.
08
Digital error.
In normal mode.
Adds error to error menu.
09
Tuner error
In initialisation state.
Adds error to error menu.
10
SP error
In initialisation state.
Adds error to error menu.
13
RTC error
In initialisation state.
Adds error to error menu.
