10
j
1/4-inch screw-type accessory shoe
k
Slide-type accessory shoe
l
Viewfinder front-to-back positioning lever
Adjusts the front-to-back position of the viewfinder attached to the
viewfinder shoe. Loosen the lever to adjust the viewfinder position,
then return the lever to the original position to secure the viewfinder.
m
Viewfinder shoe
Attach the HDVF-L10 viewfinder supplied with the HXC-FB80K.
For details about attaching, see “Attaching and Adjusting the
Viewfinder” (page 18).
n
Lens mount securing rubber
After locking the lens in position using the lens locking lever, fit this
rubber over the lower of the two projections. This secures the lens
mount, preventing it from coming loose.
o
Lens mount (special bayonet mount)
Attach a lens.
Consult your Sony dealer or a Sony service representative for
information about available lenses.
For details about attaching, see “Attaching and Adjusting the Lens”
(page 23).
p
CCU (Camera Control Unit) connector (optoelectric
composite connector)
Connect to the HXCU-FB80 4K/HD Camera Control Unit.
When connected with an optoelectric composite cable, all the
signals of the camera, comprising the power supply, control signals,
video signals, and audio signals, can be transmitted/received with
the one optoelectric composite cable.
When connected with a pair of single-mode fiber cables, all the
signals except the power supply can be transmitted/received with the
pair of single-mode fiber cables.
q
TRUNK connector (D-sub 9-pin)
Use as the trunk signal (RS-232C) input/output connector when
connected with the HXCU-FB80.
It features an assignable pin that can be used, when connected using
a dedicated cable, for a function assigned on the <EXT I/O> page in
the MAINTENANCE menu.
r
Shoulder pad
Raise the shoulder pad fixing lever to adjust the position in the front-
to-rear direction. Adjust the position for maximum convenience
when operating the camera on your shoulder.
For details about adjusting the position, see “Adjusting the Shoulder
Pad Position” (page 27).
s
LENS connector (12-pin)
Connect the lens cable.
When connecting/disconnecting the lens cable, power off the camera first.
t
AUDIO 1 IN (audio input 1) connector (XLR type, 3-pin,
female)
Connect to audio equipment or a microphone.
When the camera is connected to an HXCU-FB80, the input signal
will be output from the AUDIO OUTPUT CH-1 connector. You can
configure the camera so that the audio is embedded in the output
from the SDI output (MIC1) on the <SDI OUT> page in the
MAINTENANCE menu.
For details about connecting the microphone supplied with the
HXC-FB80K, see “Connecting a microphone to the AUDIO 1 IN
connector” (page 24).
u
Audio input 1 selector switch
Select the audio level input to the AUDIO 1 IN connector.
+48V:
To 48 V phantom power to condenser microphones
MIC:
When a microphone-level input is connected
LINE:
When a line-level (0 dBu) signal source is connected
48V when using the microphone supplied with the HXC-
FB80K.
v
Tripod mount
For details about attaching, see “Mounting on a Tripod” (page 25).
w
Lens locking lever
After inserting the lens in the lens mount, rotate the lens mount ring
with this lever to lock the lens in position.
After locking the lens, be sure to use the lens mount securing rubber
to prevent the lens from becoming detached.
x
Lens mount cap
Remove by raising the lens locking lever. When no lens is mounted,
keep this cap fitted for protection from dust.
Note
Summary of Contents for HXC-FB80
Page 71: ...Sony Corporation ...
