Sony HT-NT3, Service Manual

Page: 22 / 96

HT-NT3
22
7. Select “Reset to Factory Default Settings”, and press the [ ]
button on the remote commander.
Initialize Personal Information
Reset to Factory Default Settings
Restore each setting to the factory
default setting.
8. Select “All Settings”, and press the [ ] button on the remote
commander.
Reset to Factory Default Settings
Audio Settings
Bluetooth Settings
System Settings
Input Skip Setting
Network Settings
All Settings
9. Select “Start”, and press the [ ] button on the remote com-
mander.
All Settings
Restore all settings to the factory default
settings. The system will turn off after
reset.
Start Cancel
10. Initialization ends when the message “HELLO” on the fl uores-
cent indicator tube disappears.
SVC SERVICE MODE
Note: The operation in this mode must use a remote commander and TV
monitor.
Setting method of the SVC service mode:
1. Connect this unit with the TV monitor.
2. Press the [
?/1
] button on the main unit to turn the power on.
3. Press button in order of the [
x
]
→
[DISPLAY]
→
[
X
]
→
[
M
]
on the remote commander.
(Make the interval when each button is pressed within two sec-
onds).
4. The message “SVC” displayed on the fl uorescent indicator
tube. The OSD menu on TV monitor can be operated by the
remote commander.
1. Main Functions
• Diag
Performs unit test of devices installed on the board.
• Log
Error log is displayed. Displayed contents can also be saved in
an USB memory device.
• Factory Initialize
Restores the unit to its factory settings.
• Network
Not
used.
• Version Up
Not used.
• System Information
Displays the system information of the unit.
Displays information such as the software version, drive infor-
mation, etc.
• EMC Test Mode
Not used.
• Drive
Not
used.
• HDD Mode
Not used.
• RF Test Mode
Not used.