Sony HKSR-9003, Operation Manual

Page: 42 / 177

Basic Settings with the Subdisplay 42
Chap
ter
3
Ba
s
ic
Ad
jus
tme
nt
s
an
d Set
tings
Step mode (SHUTTER)
You can register and select up to eight frequently
used values.
Factory-set values are as follows:
Actual shutter speeds vary according to the frame
frequency and frame rate of the selected video
format. The shutter step values can be changed
and reregistered on the <SHUTTER ASSIGN>
page of the Camera >USER (OPERATION)
menu or the <SHUTTER> page of the Camera
>USER (PAINT) menu.
Continuous mode (ECS)
This mode allows you to change shutter values
continuously over the range from 360.0 to 4.3
degrees.
To obtain a continuous shutter value quickly,
select a value close to the one you want in Step
mode, and then switch to Continuous mode to
make the final selection.
Note
When operating from a remote control unit connected to
the REMOTE connector, you can control the shutter with
the SHUTTER (shutter step operation) or ECS
(continuous operation) functions. There is no need to set
ECS to ON on this unit. However, an upgrade is required
to display shutter values correctly on the remote control
unit.
For details, consult a Sony representative.
Shutter settings page
To select a shutter value in Step mode
In Step mode you can select a registered shutter
value (one of up to eight registered values) as
follows:
1
Move the cursor to the left of “SC” (
1
in the figure).
(When the unit switches to data modification
mode in the shutter settings page, the cursor
automatically appears to the left of “SC”.)
2
Turn the MENU SEL/ENTER dial to
display the shutter value that you want
to use at
2
in the figure.
The shutter values change step by step as the
MENU SEL/ENTER dial is turned.
To select a shutter value by continuous operation
Continuous operation allows you to set shutter
values freely.
1
Move the cursor to the left of “SC” (
1
in the figure).
2
Turn the MENU SEL/ENTER dial to
display the shutter value that you want
to use at
2
in the figure.
The shutter value changes continuously as
the MENU SEL/ENTER dial is turned.
To change the parameter display unit
You can change the parameter display unit
between shutter angle (degree) and shutter speed
(second).
1
Move the cursor to the left of (
2
in
the figure).
2
Turn the MENU SEL/ENTER dial.
The display at
2
changes to a speed value
(seconds).
The speed value for a given shutter angle
varies depending on the selected video
format and frame rate.
When you are not using the shutter
Select OFF at
3
.
The shutter value indication at
2
becomes “----”.
To change the registered shutter values
You can change registered shutter step values in
the <SHUTTER ASSIGN> page of the Camera
>USER (OPERATION) menu.
For details on how to operate the Camera menu, see
“Basic Camera Menu Operations” (page 89).
STEP No. Shutter angle
1 216.0°
2 180.0°
3 172.8°
4 150.0°
5 144.0°
6 90.0°
7 45.0°
8 22.5°
1 2 3