Sony HKC-7080, Installation And Maintenance Manual

Page: 34 / 92

3-12 (E)
HKC-7080
Page Ver. Item Settings Contents
Camera Setup H Phase _ 100 to 100 (
[0]
) Adjusts the H phase
FREQ SEL 60,
[59.94]
Hz Selects the field frequency
Fan Mode
[Auto1]
, Auto2, MIN, Off Auto1: Normal mode
Auto2: Silent mode
MIN:
Minimum turn mode
Off: Forcibly turned off
Link Tally On,
[Off]
On: The unit enters the above-mentioned MIN mode with a
tally signal input
Off: The mode determined by the above setting is valid all the
time
BATT Type
[Lithium]
, Others, Select according to a battery in use
CCU, Anton, BP-90 This setting enables the battery alarm voltage indication
corresponding to the battery characteristics
Alarm VOLT 10.0 to 13.0 V (
[10.0]
) Sets the battery alarm voltage (Stores the voltages for every
battery)
SDI/VTR Setup Prompter On,
[Off]
On: Prompter signal is output at PROMPTER connector
(This setting is valid only when HDCU is connected )
Off: No prompter signal is output
Serial Output On,
[Off]
On: SDI signal is output at SERIAL OUT connector
Off: No SDI signal is output (This setting is valid only when the
camera is used alone )
Optical Displays a photo-receptive condition of the optical connector of
camera adaptor
(Corresponds to the indicator on DPR-77 board of HDCU)
f)
____ : When the camera is used alone
GRN: Normal ( _ 17 dBm
*
or more)
YEW: Normal ( _ 17 to _ 20 dBm
*
)
RED: Abnormal (less than _ 20 dBm
*
)
NG: Out of sync with HDCU
*
0dBm = 1 mW
Cable COMP On,
[Off]
Turns on and off the VTR (26P) cable compensation
Output Signal RGB,
[YPbPr]
Selects the main signal to be output to a VTR
CN Output
[Main]
, RET Sets the VTR connector
Date/Time DD/MM/YY Adjusts a built-in calendar and timer
HH:MM
Area SEL GMT _ 12 to + 12 ( +
[9]
) Sets the standard time in various countries
Timer Indicates the power-on time of the unit
Camera ID Camera ID Sets a camera ID of up to ten alphanumerics, symbols, and
spaces
f) If “RED” is indicated, be sure to clean the optical connector or optical connector cable. If “YEW” is indicated, cleaning them is
recommended. For details on how to clean, refer to Section 2-15.
3-1. Setup Menu
3-1-3. Maintenance Menu