![background image](http://html.mh-extra.com/html/sony/hcd-l7hd/hcd-l7hd_service-manual_420792023.webp)
23
HCD-L7HD
PRECAUTION DURING PULLEY (RTR) ASSY, PULLEY (RTL) ASSY INSTALLATION
gear (S2)
(9 o'clock position)
claw
claw
claw
pulley (RTR) assy
pulley (RTR) assy
pulley (RTR) assy
gear (S1)
pulley (RTL) assy
pulley (RTL) assy
pulley (RTR) assy
Method of adjustment is as follows.
Raise the right gear (S1) a little and perform adjustment
by moving the left gear (S1).
Place the holes of the gear (S2) at the 9 o'clock position and install
the pulley (RTR) assy.
Install it in the way that the gear of the cut-out portion as shown is located in
between the marks of the gear (S2).
marks of the gear (S2)
Then install the pulley (RTL) assy in the way that it can perform
the symmetrical movement with the pulley (RTR) assy.
Then lock both claws.
Confirm that the pulley (RTR) contacts the claws.
Opposite to it, the pulley (RTL) assy must
have clearance of 1 to 2 mm with the claw.
It should contact with claw.
If clearance is too large or it contacts with claw,
adjustment is necessary.
1 to 2 mm
Summary of Contents for HCD-L7HD
