4
HCD-CP505
C41/Cannot Copy
The sound source is a copy of a commercially
available music software or CD-R.
c
The Serial Copy Management System prevents
making a digital copy (see page 64). In addition,
you cannot copy from a CD-R.
C71/Check OPT-IN
No component is connected to the DIGITAL
OPTICAL IN jack, or you tried to record from the
digital component which is not connected
correctly.
c
Connect the optional digital component correctly
to the DIGITAL OPTICAL IN jack using the
digital optical cable (not supplied) (see page 53).
The power of the connected component is not
turned on.
c
Check if the power of the connected digital
component is on. Refer to the operating
instructions supplied with the component.
The digital optical cable is disconnected, or the
power of the connected component is turned off
while recording the digital audio from the
component connected to the DIGITAL OPTICAL
IN jack.
c
Connect the digital optical cable, or turn on the
power of the connected component.
E0001/MEMORY NG
The component has internal problem.
c
Consult your nearest Sony dealer.
E0101/LASER NG
There is a problem with the laser pickup.
c
The laser pickup may be damaged. Consult your
nearest Sony dealer.
E0201/LOADING NG
There is a problem with the loading.
c
Consult your nearest Sony dealer.
Self-diagnosis display
This system has a Self-diagnosis display
function to let you know if there is a system
malfunction. The display shows a code made
up of three or five letters and a message
alternately to show you the problem. To solve
the problem refer to the following list. If any
problem persists, consult your nearest Sony
dealer.
C11/Protected
The MD is protected against erasure.
c
Remove the MD and slide the tab to close the
slot (see page 17).
C12/Cannot Copy
You tried to record a CD with a format that the
system does not support, such as a CD-ROM.
c
Remove the disc and turn off the system once,
then turn it on again.
C13/REC Error
Recording could not be performed properly.
c
Move the system to a stable place, and start
recording over from the beginning.
The MD is dirty or scratched, or the MD does not
meet the standards.
c
Replace the MD and start recording over from
the beginning.
C13/Read Error
The MD deck cannot read the disc information
properly.
c
Remove the MD once, then insert it again.
C14/TOC Error
The MD deck cannot read the disc information
properly.
c
Replace the MD.
c
Erase all the recorded contents of the MD using
the All Erase Function (see page 34).
Summary of Contents for HCD-CP505
Page 63: ...63 63 HCD CP505 6 18 Schematic Diagram Control Section 2 2 Page 49 Page 57 ...
Page 65: ...65 65 HCD CP505 6 20 Schematic Diagram Switch Section Page 62 Page 55 ...
Page 69: ...69 HCD CP505 6 24 Schematic Diagram OPTICAL Board J CN602 DIGITAL 470 Page 62 ...
Page 105: ...105 HCD CP505 MEMO ...