Sony DWZB70HL, Operating Instructions Manual

Page: 9 / 29

Parts Identification
9
Parts Identification
DWZ-M70
Handheld microphone (transmitter: ZTX-
M02RC)
a
Microphone unit
The standard-equipped microphone unit can be
interchanged with another interchangeable microphone
unit with a diameter of 31.3 mm and a pitch of 1.0 mm.
For details on attaching and removing the microphone
unit, see “Replacing the microphone unit” (page 13).
b
BATT/CHARGE (remaining battery / charge)
indicator
Lights when the unit is turned on. This indicates the
remaining battery charge or the charge status.
The remaining battery indication only appears when
alkaline dry cell batteries are being used.
c
POWER switch
Turns the unit on or off.
d
Grip
Contains the control buttons, channel display, and battery
compartment.
Open the grip to configure channel settings and replace
the batteries.
For details on opening the grip, see “Inserting Batteries”
(page 12).
e
Antenna cover
Contains the antenna.
Do not squeeze the antenna cover. Doing so will weaken
the signal that is transmitted, decreasing the transmission
range.
f
ATT (attenuator) switch
Set the attenuation level based on the sound volume.
The attenuator switch is located at the top of the unit when
the microphone unit is removed.
For details on attaching and removing the microphone
unit, see “Replacing the microphone unit” (page 13).
g
Channel display
Displays the transmission channel.
The display disappears after about 10 seconds. You can
display it again by pressing the channel selection button.
For details on the channel display, see “Channel
Display” (page 18).
h
Channel selection button
Allows you to select the RF mode and the transmitting
channel.
For details on selecting the RF mode and transmitting
channel, see “Configuring the Transmitting Channel
Settings” (page 17).
i
ENCRYPTION switch
Allows you to use the encrypted transmission function.
For details on the encrypted transmission function, see
“Enabling Encrypted Transmission” (page 18).
Half-rack receiver (receiver: ZRX-HR70)
a
POWER button
Turns the unit on or off.
Indicator Status
Lit (green) Good
Lit (red) Almost dead
Lit (orange) Charging
Top (when microphone unit is removed)
Grip interior
Caution
Attenuation level (dB) When to use
0 Standard switch position
6 Set to this position if a red bar
occasionally appears in the audio
level meter of the receiver.
12 Set to this position if a red bar
always appears in the audio level
meter of the receiver.
Front