Sony DWTB01/E1424, Operating Instructions Manual

Page: 19 / 32

19 Setting Menus
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
“Using the Cross Remote” on page 12.
Setting the RF output
power
(RF POWER)
You can set the RF output power.
1 mW (LOW): transmitted by 1 mW
10 mW (MID):
transmitted by 10 mW
50 mW (HIGH): transmitted by 50 mW
• The setting for this function cannot be
changed during actual signal
transmission. To change the setting, turn
off the transmitter first. Then, while
holding down the SET button, turn the
power on. And then, change the setting
after the signal transmission has stopped.
• To start signal transmission with the
selected RF output power setting, turn off
the power and then turn it on again.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
“Using the Cross Remote” on page 12.
Setting the audio input
level
(INPUT LEVEL)
You can set the input level to the analog
head amp.
Select LINE or MIC, depending on the
audio source connected to the audio input
connecter.
When MIC is selected, ATT (attenuation
level) will flash next. With the microphone
connected, speak into the microphone as
you monitor the input level meter and press
the + or – button repeatedly to select the
appropriate attenuation level.
The reference levels for the various settings
are as follows:
MIC/LINE settings and attenuator settings for the audio input level can be changed from the
receiver and other devices via the wireless remote control function.
For details on wireless remote control function, see “Using the Cross Remote” on page 12.
Notes
Input Attenuation
(dB) Reference input
level (dB) Maximum input
level (dBu) Headroom (dB)
MIC 0 –58 –22 36
3 – 55 –19
6
– 52
–16
9 – 49 –13
3 dB step 3 dB step 3 dB step
45 –
13
+23
48 – 10 +24 34
LINE – +4 +24 20