13
Using the Cross Remote
• Multiple transmitters cannot be paired
with the same receiver.
• If you reset all parameters by using the
FACTORY PRESET function
, the pairing setting of the transmitter
is also cleared.
The following transmitter settings
can be done from the remote control:
• Transmitter name setting
• Frequency band/group/channel selection
• RF transmission power setting
• MIC/LINE setting and attenuator setting
for audio input level
• Low-cut filter setting
• Power save setting
• Resetting accumulated use time
• Internal signal setting
• POWER switch lock setting
For details on menu operation, see “Setting Menus”
on page 18.
To perform remote control, the receiver must be
equipped with a control function for the setting you
want to control. For details, refer to the operating
instructions supplied with the receiver.
To cancel the Cross Remote
In the RF REMOTE indication, select OFF.
Notes on the Cross Remote
The wireless remote control function on the
transmitter uses the 2.4-GHz band and may
thus be subject to interference from other
devices.
• When pairing fails (“Pairing fail” is
displayed), successful communication
between the transmitter and the receiver
has not occurred within a given amount
of time. Pairing may be harder to do
when another receiver is engaged in
pairing nearby.
• When it becomes hard to use the remote
control, the remote control may be
improved by switching the wireless
remote control function off, then on again
in the RF REMOTE display, then re-
pairing with the transmitter (change to a
channel with less interference).
Summary of Contents for DWTB01/E1424
Page 32: ...Sony Corporation ...