background image

Receiver

Receive mode

frequence stability

sensitivity

signal to  noise ratio

audio output

power

crystal frequence lock

    15PPM

    3uV  30dB S/N

    60dB

    0~0.5V/4.7K

    AC120( 10%)

frequence stability

modulate mode

modulate degree

emission power

harmonic suppression

battery

Transmitter

15PPM

    FM

    >30KHz

  30mV MAX

    40dB

 1.5V AA battery

7

SPECIFICATION

frequence stability

modulate mode

frequence response

signal to noise ratio

maximum sound pressure

distortion factor

effective field (in the open air)

operation temperature

System specification

0.005%

    FM

  50-16000Hz

    >60dB

     120dB

     1%

    50M 

~

10     +50

C

C

O W N E R ' S        M A N U A L

W I R E L E S S   M I C R O PH O N E   S Y S T E M

To be sure you take maximum advantage of the features, read this manual 

carefully before use.

For purposes of improvement, specifications and design are subject to change without 

notice.

This manual has been checked carefully,if any mistakes because of printing or other 

reason make you puzzle, please call the dealer.

UHF 700

Summary of Contents for UHF 700

Page 1: ...ence response signal to noise ratio maximum sound pressure distortion factor effective field in the open air operation temperature System specification 0 005 FM 50 16000Hz 60dB 120dB 1 50M 10 50 C C O W N E R S M A N U A L WIRELESS MICROPHONE SYSTEM To be sure you take maximum advantage of the features read this manual carefully before use For purposes of improvement specifications and design are ...

Page 2: ...interference Applicable for medium small stages karaoke halls and homeentertainment etc Features 1 Be sure to check whether thelocal voltage accord with operativevoltage of the microphone before using make correct selection Wrong selection may leadto burnout of the whole machine 2 Please don t open or dismantle the machine on your own For internaI repair please contact the locaI distributor or acc...

Page 3: ...djust volume knobs 2 4 to the least ANTENNA INSTALLATlON AND USE HAND HOLD MICROPHONE 1 Cartridge module 2 Mic body 3 Operating indicator 4 Power switch 5 Battery cover INSTALLATION AND USE TRANSMITTER LAVALIER BODYPACK TRANSMITTER Battery Cover Wireless Transmitter Decrease the system volume Keep the transmitter away from the speakers Tune down cartridge sensitivity of the transmitter 1 Open the ...

Page 4: ...argeable batteries It has recharge equipment The recharge instructions are as below 1 When the handheld microphone is out of power during using please recharge it in time 2 Plug in the receiver screw out antenna of the microphone and connect the microphone into the recharge socket on top of the receiver the recharge signal When the batteries are recharged 3 In recharge status the receiver will aut...

Reviews: