Sony DWM-01, Operating Instructions Manual

Page: 27 / 39

27 Setting Menus
Selecting the Group/
Channel
(GP/CH)
The factory settings are as follows:
US models
U3040: 00 3001 566.125 MHz
U4250: 00 4201 638.125 MHz
European model
CE6267: 00 6201 798.125 MHz
For details, see “Selecting the Group/Channel” on
page 19.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
“Using the Wireless Remote Control Function” on
page 20.
Selecting the Frequency
Band
(BAND)
Match the frequency range on this
microphone to that of the Sony digital
wireless receiver.
The frequency range that can be set for the
optional receiver combined with this
microphone differs as follows:
US models
3040U
TV30-33, TV34-36, TV38-41
Not available for TV37
4250U
TV42-45, TV46-49, TV50-51
European model
6267CE
TV62-64, TV67-69
Not available for TV65 and TV66
For details about the frequency range of each band,
refer to “Sony Digital Wireless Microphone System
Frequency Lists” on the supplied CD-ROM.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
“Using the Wireless Remote Control Function” on
page 20.
• The setting for this function cannot be
changed during actual signal
transmission. To change the setting, turn
off the microphone first. Then, while
holding down the SET button, turn the
power on. Then change the setting after
the signal transmission has stopped.
• Be sure to select the group/channel right
after selecting the frequency band. To
start signal transmission with the selected
frequency band/group/channel, turn off
the power and then turn it on again.
Setting the RF Output
Power
(RF POWER)
You can set the RF output power.
1 mW (LOW): transmitted by 1 mW
10 mW (MID):
transmitted by 10 mW
50 mW (HIGH): transmitted by 50 mW
• The setting for this function cannot be
changed during actual signal
transmission. To change the setting, turn
off the microphone first. Then, while
holding down the SET button, turn the
power on. And then, change the setting
after the signal transmission has stopped.
• To start signal transmission with the
selected RF output power setting, turn off
the power and then turn it on again.
Notes
Notes