Sony DWM-01, Operating Instructions Manual

Page: 19 / 39

19 Attaching the Supplied Accessories / Setting the Transmission Channel
Attaching the
Supplied
Accessories
Replacing the
Identification Ring
A black ring is attached at the factory.
When multiple microphones are used in the
system, identification rings with different
colors are useful to distinguish a
microphone from another.
Setting the
Transmission
Channel
The microphone provides groups of
interference-free channels. When using
multiple microphones and transmitters at
the same time (simultaneous multi-channel
operations) within the same area, selecting
the same group and using a channel within
that group can prevent signal interference.
To set the transmission channel on the
microphone, first you select the group and
channel using the RF indicator and
scanning functions on the receiver. Next
you set the group and channel parameters to
match the setting on the receiver.
Selecting the Group/
Channel
• Before doing this procedure, use the
BAND function (see page 27) to set the
microphone to the bandwidth of the
receiver you are using.
• The setting for this function cannot be
changed during actual signal
transmission.
Set the microphone group (GP) and channel
(CH) as follows:
For details on groups and channels, refer to “Sony
Digital Wireless Microphone System Frequency
Lists” on the supplied CD-ROM.
For details on menu operation, see “Basic Menu
Operations” on page 25.
Rotate and
remove the ring
holder to
replace the
identification
ring.
Notes