Sony DS-HMD1, Operating Instructions Manual

Page: 27 / 88

27
-GB
The drive failed to
store data. • Damage to the data occurred because the computer
changed to system suspend, sleep, or hibernation
mode while the drive was still connected to the
computer.
, Disable the system suspend, sleep, or hibernation
function on the computer and repeat the writing
operation.
• The USB cable has been disconnected.
, Connect the supplied USB cable firmly to the
computer before writing.
The drive is not
correctly
recognized by
SonicStage. • The drive is not firmly connected with the supplied
USB cable to the computer.
,
Disconnect the USB cable, restart the computer,
and then make the connection again.
• A disc is not inserted in the drive.
,
Check if a disc is inserted in the drive.
• SonicStage installation failed.
, Disconnect the USB cable and install the software
again using the supplied CD-ROM.
• The connections are made through a USB hub.
, Operations are not guaranteed for USB hub
connections. Use the supplied USB cable to
connect the drive directly to the USB port on the
computer.
• You are using a computer on which the supplied
SonicStage has not been installed.
, Install SonicStage from the supplied CD-ROM.
Even though the
supplied USB
cable is used to
connect the drive
to the computer,
the ACCESS lamp
does not light up. • It takes time to recognize SonicStage.
,
Please wait.
• Another application software is running.
, Reconnect the supplied USB cable after a while.
If the computer still does not recognize the drive,
disconnect the USB cable, restart the computer,
and connect it again.
The drive does not
respond or does
not operate
correctly. • Moisture has condensed inside the drive (for example,
when the drive has been brought in from a cold place
to a warm place).
,
Take the disc out and leave the drive in a warm
place for several hours until the moisture
evaporates.
Symptom Cause/Remedy