Troubleshooting
110
Digital program editing on the tape
does not function.
c
Set the input selector on the VCR correctly, then check the connection
between your camcorder and the VCR. (p. 86)
c
When your camcorder is connected to a DV device that is not a Sony
product via an i.LINK cable, select [IR] in step11 of “Step 1: Preparing
your camcorder and VCR for operation” (p. 91).
c
Adjust the synchronization of the VCR. (p. 94)
c
Enter a correct [IR SETUP] code. (p. 93)
c
Select the mode used to cancel recording pause again. (p. 92)
c
Set your camcorder and the VCR more than 30 cm (12 in.) apart. (p. 92)
• The program may not be set to a blank section on the tape.
The VCR is not responding properly
during Digital program editing when
it is connected via an i.LINK cable.
• While connecting via an i.LINK cable, select [IR] in step 11 of “Step 1:
Preparing your camcorder and VCR for operation” (p. 91).
Digital program editing on the
“Memory Stick” does not function
correctly.
• The program may not be set to a blank section on the tape.
• You cannot record or a distorted picture may be recorded if the tape has
been used repeatedly for recording.
Symptom
Cause and/or Corrective Actions