masterpage:Right
specdef v20080115
filename[E:\sagyou\080603\OLD\3398072142\3398072142\3398072142DAVF500CA2\gb04gst.f
m]
model name [DAV-F500]
[3-398-072-
14
(2)]
31
GB
Gettin
g
Star
ted
To install the control unit on the wall
Be sure to disconnect the AC power cords of all components from their wall outlets (mains) before
installing the control unit on the wall.
1
Remove the screws, then detach the stand from the control unit.
2
Peel the 4 seals (
A
) off the screw positions on the rear of the control unit.
3
Attach the wall mounting bracket (for control unit) to the control unit using the supplied
screws.
1
Draw the system cable through opening (
B
) of the bracket (for control unit).
2
Attach the 3 hooks (
C
) of the bracket (for control unit) to the control unit.
3
Secure the bracket (for control unit) with the 4 supplied screws (middle).
4
Attach the bracket (for wall) to the wall.
Before attaching, make sure that the wall is sufficiently strong.
1
Decide the installation location for the bracket (for wall).
– Allow sufficient space around screw hole (
D
): 150 mm above, 150 mm below, 250 mm to
the left, and 400 mm to the right (disc slot side).
– Screw hole (
D
) will be the center of the control unit’s width.
– The location 72.5 mm above from the screw hole (
D
) will be the top of the control unit.
2
Secure the bracket (for wall) to the wall with 12 commercially-available screws.
To Customers
Sufficient expertise is required for installing this product. Be sure to subcontract the installation to Sony dealers or
licensed contractors and pay special attention to safety during the installation. Sony is not liable for any damages
or injury caused by mishandling or improper installation, or installing any other than the specified product. Your
Statutory Rights (if any) are not affected.
To Sony Dealers
The following instructions are for Sony Dealers only. Be sure to read safety precautions and pay special attention
to safety during the installation, maintenance and checking of this product.
A
A
A
A
B
C
C
C
