Sony Cyber-Shot DSC-RX10M4, Help Manual

Page: 579 / 593

Help Guide
Digital Still Camera
DSC-RX10M4
Precautions
Refer also to “Notes on using your camera” in the Instruction Manual (supplied) for this product.
Backing up memory cards
Data may be corrupted in the following cases. Be sure to back up the data for protection.
When the memory card is removed, the USB cable is disconnected, or the product is turned off in the middle of a
read or write operation.
When the memory card is used in locations subject to static electricity or electrical noise.
Database file error
If you insert a memory card that does not contain an image database file into the product and turn on the power, the
product automatically creates an image database file using some of the memory card’s capacity. The process may take a
long time and you cannot operate the product until the process is completed.
If a database file error occurs, export all images to your computer using PlayMemories Home, and then format the
memory card using this product.
Do not use/store the product in the following places
In an extremely hot, cold or humid place
In places such as in a car parked in the sun, the camera body may become deformed and this may cause a
malfunction.
Storing under direct sunlight or near a heater
The camera body may become discolored or deformed, and this may cause a malfunction.
In a location subject to rocking vibration
Near strong magnetic place
In sandy or dusty places
Be careful not to let sand or dust get into the product. This may cause the product to malfunction, and in some cases
this malfunction cannot be repaired.
In places with high humidity
This may cause the lens to mold.
On storing
If the camera is dirty after use, clean it. Water, sand, dust, salt, etc. left in the camera may cause a malfunction.
Precaution on carrying
Do not carry the camera with the tripod attached. This may cause the tripod socket hole to break.
Do not apply excessive force to the camera, such as by holding the monitor or flash part, hitting the lens part, etc.
On operating temperatures
Shooting in extremely cold or hot places that exceed this range is not recommended.
On moisture condensation
If the product is brought directly from a cold to a warm location, moisture may condense inside or outside the
product. This moisture condensation may cause a malfunction of the product.
To prevent moisture condensation when you bring the product directly from a cold to a warm location, first put it in a
plastic bag and seal it to prevent air from entering. Wait for about an hour until the temperature of the product has
579