Sony Cyber-shot DSC-HX99, Help Manual

Page: 494 / 511

In sandy or dusty places
Be careful not to let sand or dust get into the product. This may cause the product to malfunction, and in some cases
this malfunction cannot be repaired.
In places with high humidity
This may cause the lens to mold.
In areas where strong radio waves or radiation are being emitted
Recording and playback may not function correctly.
On moisture condensation
If the product is brought directly from a cold to a warm location, moisture may condense inside or outside the
product. This moisture condensation may cause a malfunction of the product.
To prevent moisture condensation when you bring the product directly from a cold to a warm location, first put it in a
plastic bag and seal it to prevent air from entering. Wait for about an hour until the temperature of the product has
reached the ambient temperature.
If moisture condensation occurs, turn off the product and wait about an hour for the moisture to evaporate. Note that
if you attempt to shoot with moisture remaining inside the lens, you will be unable to record clear images.
Precaution on carrying
Do not hold, hit, or apply excessive force to the following parts, if your camera is equipped with them:
The lens part
The movable monitor part
The movable flash part
The movable viewfinder part
Do not carry the camera with the tripod attached. This may cause the tripod socket hole to break.
Do not sit down in a chair or other place with the camera in the back pocket of your trousers or skirt, as this may
cause malfunction or damage the camera.
Notes on handling the product
Before you connect the cable to the terminal, be sure to check the orientation of the terminal. Then, insert the cable
straight. Do not insert or remove the cable forcefully. This may cause the terminal part to break.
The camera uses magnetic parts including magnets. Do not bring objects affected by magnetism, including credit
cards and floppy disks, close to the camera.
The recorded image may be different from the image you monitored before recording.
On storing
For lens-integrated cameras
Always attach the lens cap when you are not using the camera. (Only for models supplied with a lens cap)
For interchangeable-lens cameras
Always attach the lens front cap or body cap when you are not using the camera. To prevent dust or debris from
getting inside the camera, remove dust from the body cap before attaching it to the camera.
If the camera is dirty after use, clean it. Water, sand, dust, salt, etc. left in the camera may cause a malfunction.
Notes on using lenses
When using the power zoom lens, be careful not to get your fingers or any other objects caught in the lens. (Only for
models with a power zoom feature or interchangeable lens cameras)
If you must place the camera under a light source such as sunlight, attach the lens cap to the camera. (Only for
models supplied with a lens cap or interchangeable lens cameras)
When you shoot with backlighting, keep the sun sufficiently far away from the angle of view. Otherwise, the sunlight
may enter the focus inside the camera and cause smoke or fire. Even if the sun is slightly away from the angle of
view, it may still cause smoke or fire.
Do not directly expose the lens to beams such as laser beams. That may damage the image sensor and cause the
camera to malfunction.
If the subject is too close, the image may show any dust or fingerprints on the lens. Wipe the lens with a soft cloth,
etc.
494