15-GB
Troubleshooting
If any problems occur with your products, refer to the following solutions.
If the problem persists, contact your Sony dealer.
Symptom
Unable to charge the battery pack
(when the CHARGE lamps fail to light)
One of the CHARGE lamps blinks
All the CHARGE lamps blink
The CHARGE lamps light up even
though the camera is not placed on the
Cyber-shot Station
Unable to turn on the camera, or
it suddenly gets turned off
The images/sounds cannot be played
back on a TV
The images/sounds cannot be played
back on the screen of the camera
Cause/Solution
• The camera is turned on.
t
Turn the camera off.
• The AC Adaptor is disconnected.
t
Connect the AC Adaptor properly.
• The camera is not placed on the Cyber-shot Station
correctly.
t
Place the camera correctly.
• The battery pack is not installed correctly.
t
Install the battery pack correctly.
• The battery pack is completely charged.
• The battery pack installed into the camera is
inapplicable.
t
Install the battery pack compatible with your
camera.
• The battery pack installed into the camera is
inapplicable.
t
Install the battery pack compatible with your
camera.
• The connection is not correct.
t
Remove the camera from the Cyber-shot
Station and reconnect the AC Adaptor. After
the CHARGE lamps go off, place the camera
on the Cyber-shot Station.
• The connection is not correct.
t
Remove the camera from the Cyber-shot
Station and reconnect the AC Adaptor. After
the CHARGE lamps go off, place the camera
on the Cyber-shot Station.
• The Cyber-shot Station is in the demonstration
mode because you may have pressed the Control
buttons in the order of
v
/
b
/
V
/
B/
POWER,
without the camera placed on the Cyber-shot
Station.
t
To cancel the demonstration mode, discconect
the AC Adaptor once and connect it again, or
place the camera on the Cyber-shot Station.
• The camera is not placed on the Cyber-shot Station
correctly.
t
Place the camera correctly.
• The AC Adaptor is disconnected.
t
Connect the AC Adaptor properly.
• The connection is not correct.
t
Make sure that the connection is correct.
• The DISPLAY SELECT switch is not set to “TV”.
t
Set the DISPLAY SELECT switch to “TV”.
• The DISPLAY SELECT switch is not set to
“CAMERA”.
t
Set the DISPLAY SELECT switch to “CAMERA”.
