![background image](http://html.mh-extra.com/html/sony/cmt-px5/cmt-px5_operating-instructions-manual_420430008.webp)
8
3
Press – or +.
The frequency indication changes and the
scanning stops when the system tunes in a
station. “TUNED” and “STEREO” (for a
stereo programme) appear.
If “TUNED” does not appear
and the scanning does not
stop
Press TUNING MODE repeatedly until
“MANUAL” appears, then press – or + to
tune in the desired station.
4
Press MENU/NO.
5
Press – or + repeatedly until
“Memory?” appears, then press
ENTER/YES.
The preset number starts flashing. Perform
steps 6 and 7 while the preset number is
flashing.
6
Press – or + repeatedly to select the
desired preset number.
Select from 1 to 20 for FM and 1 to 10 for
AM.
7
Press ENTER/YES.
“Complete!” appears, and then the station is
stored.
8
Repeat steps 1 to 7 to preset other
stations.
To stop scanning
Press MENU/NO.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until
“MANUAL” appears in step 2, then press – or +
repeatedly to tune in the station manually.
To change the preset number
Start over from step 1.
To change the AM tuning interval
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
the system. While holding down the FUNCTION,
turn the system back on. When you change the
interval, all the AM preset stations are erased. To
reset the interval, repeat the same procedure.
Tips
• The preset stations are retained for about a day even
if you disconnect the mains lead or if a power failure
occurs.
• You can label the preset stations (see page 55).
Step 3: Presetting radio
stations (continued)