HCD-G1BiP/G1iP
10
2-4. PANEL (FRONT) BLOCK
– Rear side view –
1
Lift up the coating clip.
4
Lift up the coating clip.
5
Turn over the flexible
flat cable (15 core).
2
connector
(CN805)
3
connector
(CN601)
6
flexible flat cable (17 core)
(CN404)
7
two screws
(BV3)
0
claw
0
claw
9
two screws
(BV/ring)
qa
panel (front) block
8
screw
(BVTP3
u
8)
8
screw
(BVTP3
u
8)
– Front panel inner view –
front side
sleeve ferrite clamp
HP board
USB board
JOG2 board
coating clip
CD mechanism deck
tape
flexible flat
cable (17 core)
flexible flat cable (15 core)
MAIN board
MAIN board
AMP board
coating clip
coating clip
tape
The wire must be on the
sleeve ferrite clamp.
The sleeve ferrite clamp must
come under the USB board.
:LUHVHWWLQJ
front side
front side
Note 2: When you install the panel (front) block,
put two sleeve ferrite clamps within this
dotted line range.
Note 3: Confirm the BD94D board has not dropped.
Insert is straight to the interior.
Insert is incline
flexible flat
cable
flexible flat
cable
connector
connector
OK
NG
Note 4: When you install the flexible flat cable, please install them
correctly.
There is a possibility that this machine damages when not
correctly installing it.
Note 1: There is a possibility of damaged of the panel (CD tray) when the
panel (front) block is removed without removing the panel (CD tray).
Remove panel (CD tray) earlier than removing the panel (front) block.
