Sony Cineza VPL-HS60, Operating Instructions Manual

Page: 47 / 68

47 GB
Troubleshooting
Oth
e
rs
Warning messages
Caution messages
Message Lists
Message Cause and Remedy
High temp.! Lamp off in 1
min.
c
Turn off the power.
c Check to see if nothing is blocking the ventilation holes.
Frequency is out of range!
c
Input a signal that is within the acceptable range of the
frequency.
c Set the output signal on an external monitor of the connected
computer to SVGA.
c
Set “Input-A Signal Sel.” in the Setup menu to
“Computer”. ( 1 page 42)
Please check Input-A
Signal Sel.
c
Set “Input-A Signal Sel.” in the Setup menu to
“Computer” when RGB signal is input from the computer. ( 1
page 42)
Please replace the LAMP. c It is time to replace the lamp. Replace the lamp. ( 1 page 48)
Please replace the filter.
c
It is time to replace the air filter. Replace the air filter. (
1
page
49)
High temp.!
Probably use in high
altitude. Switch to high
altitude mode on? Yes:
O
/
No:
o
c
When using the projector at an altitude of 1,500 m or higher:
select “Yes” to set to “High Altitude Mode”. (
1 page 41)
c If this message is displayed when using the projector at an
altitude of less than 1,500 m: check to see if nothing is blocking
the ventilation holes.
Message Cause and Remedy
c
No signal is input in the selected input. Check connections. (
1
page 13)
Not applicable!
c
Press the appropriate button.
x