![background image](http://html.mh-extra.com/html/sony/chc-p33d/chc-p33d_operating-instructions-manual_420253006.webp)
Chapter 1: Setting up
EN
6
Fastening the speaker
stands
1
Fasten the four screws loosely using the
supplied wrench.
2
Rotate the speaker to the desired
position.
You can also rotate the Sony logo.
3
Tighten the screws.
Note
Tighten the screws securely to prevent
mechanical noise.
To attach the cord holder to the
speaker stand
Peel off the sheets covering the cord
holders and attach the holders to the
speaker stands.
When attaching the
speakers to the wall
1
Detach the caps and plates from the
speaker stands.
Wrench
Screw
Setting the Clock
The built-in clock shows the time in the
display. You need to set the clock to utilise
the timer-activated features of your stereo
system.
=
+
1
2,4
3,5
DISPLAY
1
Press CLOCK SET.
The hour indication begins flashing.
2
Set the current hour by turning the jog
dial until the correct hour appears.
3
Press ENTER/NEXT.
The minutes indication begins flashing.
4
Set the current minute by turning the jog
dial until the correct minute appears.
5
Press ENTER/NEXT.
The clock starts running and the upper
dot flashes. Use the time signal to set
the clock accurately.
The upper dot flashes for the first half of
a minute (0 to 29 seconds), and the
lower dot flashes for the last half of a
minute (30 to 59 seconds).
To check the time while power is on
Press DISPLAY.
The current time appears for a few seconds.
To correct the clock setting
Repeat steps 1 to 5.
2
Use a screw driver to attach the stands
to the wall with four wood screws (not
supplied).
3
Re-attach the caps and plates to the
speaker stands.
Note
Before attaching the speakers, check the
strength of the wall and the length of the
wood screws to prevent the speakers from
falling down.
flashing
flashing
flashing
flashing
S
Inserting the
Batteries
Insert two R6 (size AA) batteries in the
supplied remote for remote control.
1
Open the lid.
2
Insert two R6 (size AA) batteries.
Match the + and – indications to the
diagram in the battery compartment.
3
Close the lid.
Battery life
You can expect the remote to operate for
about six months (using Sony SUM-3 (NS)
batteries) before the batteries run down.
When the batteries no longer operate the
remote, replace both batteries with new
ones.
To avoid battery leakage
If you are not going to use the remote for a
long time, remove the batteries to avoid
damage caused by corrosion from battery
leakage.