CDX-G1200U/G1201U/G1202U/G1280UM
9
Cautions
•
Run all ground (earth) leads to a
common ground (earth) point.
• Do not get the leads trapped under a
screw, or caught in moving parts (e.g., seat
railing).
• Before making connections, turn the car
ignition off to avoid short circuits.
• Connect the power supply lead
ͫ
to the
unit and speakers before connecting it to
the auxiliary power connector.
• Be sure to insulate any loose unconnected
leads with electrical tape for safety.
• Choose the installation location carefully so
that the unit will not interfere with normal
driving operations.
• Avoid installing the unit in areas subject to
dust, dirt, excessive vibration, or high
temperature, such as in direct sunlight or
near heater ducts.
• Use only the supplied mounting hardware
for a safe and secure installation.
Note on the power supply lead (yellow)
When connecting this unit in combination with
other stereo components, the amperage rating of
the car circuit to which the unit is connected must
be higher than the sum of each component’s fuse
amperage rating.
Mounting angle adjustment
Adjust the mounting angle to less than 45°.
Connection/Installation
Precautions
Subwoofer Easy Connection
You can use a subwoofer without a power
amplifier when it is connected to a rear
speaker cord.
Notes
• Preparation of the rear speaker cords is required.
• Use a subwoofer with an impedance of 4 Ω to 8 Ω,
and with adequate power handling capacities to
avoid damage.
Memory hold connection
When the yellow power supply lead is
connected, power will always be supplied to
the memory circuit even when the ignition
switch is turned off.
Speaker connection
• Before connecting the speakers, turn the
unit off.
• Use speakers with an impedance of 4 Ω to
8 Ω, and with adequate power handling
capacities to avoid damage.
Front speaker
Subwoofer
If you have a power antenna (aerial) without
a relay box, connecting this unit with the
supplied power supply lead
ͫ
may damage
the antenna (aerial).
ɞ
To the car’s speaker connector
Making connections
1
Rear speaker
(right)
È
Purple
2
¾
Purple/black
striped
3
Front speaker
(right)
È
Gray
4
¾
Gray/black
striped
5
Front speaker
(left)
È
White
6
¾
White/black
striped
7
Rear speaker
(left)
È
Green
8
¾
Green/black
striped
ɟ
To the car’s power connector
12
continuous power
supply
Yellow
13
power antenna (aerial)
/power amplifier
control (REM OUT)
Blue/white
striped
15
switched power
supply
Red
16 ground (earth)
Black
Connection
*1 Not supplied
*2 Speaker impedance: 4 Ω – 8 Ω × 4
*3 RCA pin cord (not supplied)
*4 Depending on the type of car, use an adaptor for
a wired remote control (not supplied). For details
on using the wired remote control, see “Using
the wired remote control” (page 23).
*5 Depending on the type of car, use an adaptor
(not supplied) if the antenna connector does not
fit.
ͫ
from a wired remote control
(not supplied)*
4
from a car antenna (aerial)
*5
*
3
*
3
Subwoofer*
1
For details, see “Making
connections” (page 22).
Power amplifier*
1
See “Power connection diagram” (page 22)
for details.
*
2
.
.
(AEP, UK, HK)
