Sony CCD-TRV128, Service Manual

Page: 90 / 179

Getting started
Get
ting st
art
e
d
13
After charging the battery
The CHG (charge) lamp turns off when the
battery is fully charged. Disconnect the AC
Adaptor from the DC IN jack.
To remove the battery pack
1
Lift up the viewfinder.
2
Set the POWER switch to (CHG) OFF.
3
Slide the battery pack out in the direction
of the arrow while pressing the BATT
(battery) release button down.
b
Note
• If you do not use the battery pack for a long time, use
up the battery pack completely before storing it. See
page 83 about storage of the battery pack.
To check the remaining battery – Battery
Info
You can check the battery's current charge level
and its current remaining recording time both
during charging or when the power is turned off.
1
Set the POWER switch to (CHG) OFF.
2
Press OPEN and open the LCD panel.
3
Press DSPL/BATT INFO.
The battery information appears for about 7
seconds.
Keep the button pressed to view it for about
20 seconds.
A
Battery charge level: Displays
approximate remaining amount of
power left in the battery pack.
B
Approximate possible recording time
using the LCD panel.
C
Approximate possible recording time
using the viewfinder.
Charging time
Approximate number of minutes required when
you fully charge a fully discharged battery pack
at 25°C (77°F). (10 – 30°C (50 – 86°F)
recommended.)
Recording time when recording with the
LCD screen on
Approximate number of minutes available
when you use a fully charged battery pack at
25°C (77°F).
BATT (battery)
release button
POWER switch
POWER switch
OPEN
DSPL/BATT INFO
Battery pack
NP-FM30 (supplied) 145
NP-FM50 150
NP-QM71/QM71D 260
NP-QM91/QM91D 360
BATTERY INFO
BATTERY CHARGE LEVEL
REC TIME AVAILABLE
0% 50% 100%
LCD SCREEN: 81 min
VIEWFINDER: 112 min
, continued