77
Cleaning the Recorder Connector / About “Memory Stick Duo”
App
end
ix
Cleaning the Recorder
Connector
Before cleaning the recorder connector, always check that
the power supply is disconnected before proceeding.
If the recorder connector is dirty, there is increased risk of
errors in the data transmission between the camera and the
SR-R4. The recorder connector should be cleaned if any of
the following conditions occurs.
• DOCK indicator is lit yellow or red.
• DIAGNOSIS indicator is lit red and the “CRCC Error
occurred” message is displayed.
You will need the following items in order to clean the
recorder connector:
• Commercially available optical fiber cleaning swabs
• 99.5% (or higher) pure alcohol
1
Remove the SR-R4. If the SR-R4 was not connected,
remove the connector cap from the recorder connector.
2
Press the recorder connector using your finger
1
, and
open the protective shutter to expose the optical
contacts.
3
Dip an optical fiber cleaning swab in alcohol and
gently wipe the whole optical contacts area about five
times.
• Always use alcohol only in well-ventilated areas
away from heat or flame.
• Wiping firmly may damage the optical fiber
contacts.
4
Release the connector’s protective shutter, and connect
the SR-R4. If not connecting the SR-R4, reattach the
connector cap.
About “Memory Stick
Duo”
Supported types of “Memory Stick”
You can use “Memory Stick Duo” or “Memory Stick PRO
Duo.”
The camera operations have been checked using “Memory
Stick” media up to 32 GB.
This camera is not compliant with high-speed data transfer
with this type of “Memory Stick.”
Operations checked with:
MSX-M2GN
MSX-M1GST
MSX-M2GST
MS-HX8
MS-HX32
MS-MT2G
MS-MT4G
MS-MT16G
MS-MT32G
Note on data read/write speed
Data read/write speed may vary depending on the
combination of the “Memory Stick” and “Memory Stick”
compliant product you use.
Inserting a “Memory Stick Duo”
Insert a “Memory Stick Duo” with the label side facing left
into the “Memory Stick Duo” slot until it clicks and the
access lamp lights in red. Check that the access lamp then
goes off.
If it does not fit into the slot properly or if there is some
resistance when you insert it, the “Memory Stick Duo”
may be turned around or upside-down. Do not force the
“Memory Stick Duo” into the slot. Confirm the direction
of the notch and arrow on the “Memory Stick Duo” before
Note
Notes
Optical contacts
Note
Access lamp
