13
SKC-4001 ST 2110 Interface Kit (Option)
For safety, only a qualified technician with service training
should perform tasks inside the unit.
Connection with devices that are SMPTE ST 2110 compliant
is supported by installing an SKC-4001 in the BPU4500A.
BPU4500A software version 3.02 or later is required. In
addition, an OTM-25GSR1 or other SFP28 module is required
to use IP output.
The following diagram shows the rear panel of the BPU4500A
with the SKC-4001 installed.
a
LAN1, LAN2 connectors (SFP28)
Outputs IP video and audio signals. Output of one 4K signal
and two HD signals from the BPU4500A is supported.
For connection with an RCP/MSU device or IP tally input, use
the LAN connector of the BPU4500A.
The output signal format is set using the <OUTPUT FORMAT>
page of the CONFIGURATION menu.
b
LAN3, LAN4 connectors (SFP28)
Outputs IP video and audio signals. Output of one 4K signal or
HD signal from the BPU4500A is supported.
The output signal format is set using the <OUTPUT FORMAT>
page of the CONFIGURATION menu.
About disconnecting LC connectors
When connecting to other models using the LAN3 and LAN4
connectors of the SKC-4001, unlock the LC connectors and
pull the connectors out from the unit as described below.
Push and hold down the unlock plate (A) and grasp the LC
connector and pull the connector out (B). (The LC connector is
unlocked by pushing down on the unlock plate.)
Note
a
LAN1, LAN2
connectors
b
LAN3, LAN4 connectors
(A)
(B)
LC connector
Unlock plate
LC connector
LC connector
Unlock plate
Rear fan
