11
MONI
STATUS
PROT
LOCK
(CHOP)
BKS-R1618
U
-
AC IN
REMOTE 2
RS-232C
REMOTE 1
MONI
STATUS
PROT
LOCK
(CHOP)
BKS-R3219
0
REMOTE 2 connector
8
REMOTE 1 connector
5
Source/destination select buttons
Locations and Functions of Parts
Front panel
Rear panel
6
~AC IN connector
7
U
(ground) connector
9
RS-232C connector
Front panel
BKS-R3219
BKS-R1618
BKS-R3219/R1618
1
STATUS button/lamp
2
MONI button/lamp
4
LOCK (CHOP) button/lamp
3
PROT button/lamp
5
Source/destination select buttons
1
STATUS button/lamp
4
LOCK (CHOP) button/lamp
3
PROT button/lamp
2
MONI button/lamp
1
STATUSbutton/lamp
The button lights in red when some trouble occurs with
the unit.
When the TALLY display is set to ON, the TALLY
status of the set destination is shown in red or green.
The red tally signal has priority.
2
MONI (monitor) button/lamp
When you press and light the button, the destination
set on the control terminal is monitored, and the source
selected for the destination or the source that the offset
value is added is automatically selected.
For details on setting the monitor, refer to the installation
manual supplied with the routing switcher.
3
PROT (protect) button/lamp
This button has two functions: to set and release
protection for the output connector (destination) and to
indicate whether the currently selected destination is
protected or not.
Protection indication function
When the currently selected destination is protected,
the lamp is lit, and the source select buttons are
disabled. When the protection is set on this unit, the
lamp is lit in green, while it is lit in red when the
protection is set on another unit.
Protection function
When you press this button, the button lights and the
currently selected destination (output) is protected.
When a destination is protected, switching of sources
for the destination is disabled.
To release protection, press the PROT button so that
the lamp goes out.
Note
If the protection has been set to ON AIR mode at the
control terminal, switching is enabled independently
ofthe protection setting. Normally set the protection to
NORMAL mode.
