1-2(E)
1(E)
Table of Contents
Overview ........................................................................... 2(E)
Using with BVM-Series Video Monitors ........................ 2(E)
Functions ..................................................................... 2(E)
Using the Input and Output Connectors ..................... 3(E)
Combination of Multiple Adaptors ............................. 3(E)
Using with HDM-Series Video Monitors ....................... 5(E)
Functions ..................................................................... 5(E)
Using the Input and Output Connectors ..................... 5(E)
Specifications .................................................................... 6(E)
Installing into Video Monitors ........................................ 7(E)
English
2(E)
Using with BVM-Series Video Monitors
OFF
ON
OFF
ON
SW1
SW2
SW3
SW4
SW5
SW6
To set the grounded mode, insert the jumper-pins into
the ON slot and the center slot. To set the floating
mode, insert the jumper-pins into the OFF slot and the
center slot.
The factory preset is grounded mode.
Floating mode is useful for rejecting common mode
noise.
Overview
Functions
The BKM-48X HD Analog Input Expansion Adaptor
is a video signal input adaptor for BVM-Series and
HDM-Series video monitors.
When installed in an input option slot on the rear panel
of the video monitor, it provides video input and
output connectors for the monitor.
Expansion of Analog Composite Inputs
The BKM-48X is not equipped with decoders, but if
decoder adaptors are installed in other input option
slots, you can use them to decode analog composite
signals input to the BKM-48X.
Expansion of analog component inputs is also
possible.
Analog Input and Output Signal
Connectors
The BKM-48X is equipped with six input and six
output connectors. You can input two Y/R–Y/B–Y,
RGB or YC signals, or six analog composite signals
to the input connectors. The types of analog
composite signals that may be input vary depending
on the input adaptors installed in other input option
slots (see page 4(E)).
Floating System
Each input connector can be selected to either
floating or grounded mode by the switches on the
board (SW1 to SW6, shown in the figure on the right
column).
Grounded mode
Floating mode
About the Software Version of the Monitor
Installed
The following software versions are necessary to use
the BKM-48X with your monitor.
•
For BVM-E, -F series monitor : Version 1.30 or later
•
For BVM-G series monitor :
Version 1.00 or later
•
For HDM series monitor :
Version 1.10 or later
If the software version of your monitor is previous to
those listed above, contact your nearest Sony dealer or
Sony service facility for an upgrade.
